Electrical Installation - Speck pumps BADUJET Inspiration Manual De Servicio, Instalacion Y Funcionamiento

Installation (Above-Ground or On-Ground Pools) - continued
10. Remove the telescopic safety support and drill holes with the 10mm concrete bit provided. NOTE: Drill holes 1-1/4" deep.
11. Insert the four (4) M8 pool deck anchors (part# 49/9) into the holes.
12. Repeat Step 8 to attach the telescopic safety support to the BaduJet Inspiration. Be sure that the bolts are tight. Fasten
the base of the telescopic safety support with four (4) M8 x 50mm bolts (part# 49/8), four (4) 8.4mm lock washers (part#
49/6), and four (4) 8.4mm washers (part# 49/5).
13. Continue to the Initial Start-Up Section on page 12.

Electrical Installation

The BaduJet Inspiration requires a 208-230V twist lock receptacle.
WARNING: ALL WIRING FOR NEW OUTLETS OR ANY CHANGES IN WIRING TO THE BADUJET INSPIRATION MUST BE
COMPLETED BY A LICENSED ELECTRICIAN IN ACCORDANCE WITH ALL FEDERAL, STATE, AND LOCAL CODES.
WARNING: UNPLUG THE GFCI CORD before servicing the control box. Serious injury or death may occur due to electric shock.
The BaduJet Inspiration includes a 15 ft. cord with GFCI and twist-lock plug. If necessary, the cord may be cut shorter using
the following instructions:
1. Measure the amount of cord to be cut.
2. Open the control box and disconnect Line
1, Line 2, and Ground. See Figure for the
control box wiring diagram. Loosen the liquid
tight strain relief for the electrical cord.
3. Pull the amount of cord to be cut through
the strain relief and toward the control box.
4. Cut excess cord at the control box. Strip
back wire insulation and install Line 1, Line
2, and Ground using Figure 6 Replace the
control box cover.
Line 1 Line 2
Figure 6 - Control Box Wiring - Image
Ground
11