General Safety Instructions - Speck pumps BADUJET Inspiration Manual De Servicio, Instalacion Y Funcionamiento

Manufacturers Warnings - continued
13. Consult your physician before exercising with the BaduJet Inspiration or using the massage hose.
14. DO NOT remove any safety alert labels such as DANGER, WARNING, or CAUTION. Keep safety alert labels in
good condition and replace missing or damaged labels.
15. Stay alert, watch what you are doing and use common sense. DO NOT use unit if you are tired and/or
exhausted. DO NOT use unit while under the influence of drugs, alcohol, or any medications.
NOTE: To the installer and/or operator of the Speck SwimJet System; the manufacturer's warranty will be voided
if this product is improperly installed and/or operated.
IMPROPER INSTALLATION OR USE OF THIS PRODUCT MAY PRESENT A RISK OF HAIR OR BODY ENTRAPMENT
AND DROWNING. Install this equipment in accordance with the instructions provided.
As the manufacturer, Speck Pumps - Pool Products, Inc., hereby certifies that their Swim Jet Combination Fitting
meets or exceeds the requirements of the Virginia Graeme Baker Pool & Spa Safety Act, VGB 2008 and ANSI/
APSP 16-2011 standards and safety regulations as set forth by the Consumer Products Safety Commission.
"Read, and then keep these instructions for future reference"

General Safety Instructions

The following guidelines provide information to minimize the risk of injury to users of pools, spas, and hot tubs.
WARNING: TO REDUCE THE RISK OF ENTRAPMENT HAZARD
Pool and spa pumps produce high levels of suction, which can pose extreme danger if a person comes in close
proximity to an open pool or spa drain or if a drain cover is loose, cracked, broken or missing. Pool and spa pumps
move large volumes of water, which can pose extreme danger if a person's hair comes in close proximity to a
drain that is not the proper size for the pump or pumps.
If not an approved single, unblockable outlet, a minimum of two functioning suction outlets per pump must be
installed. Suction outlets in the same plane (i.e. floor or wall) must be installed a minimum of three (3) feet (1
meter) apart, as measured from center point to center point. Dual suction fittings shall not be located on seating
areas or on the backrest for such seating areas. If any suction outlets are located closer they shall be located on
two di erent planes (i.e. one on the bottom and one on the vertical wall, or one each on two separate vertical
walls).
WARNING: Failure to keep suction outlet components clear of debris, such as leaves, dirt, hair, paper and other
material can result in an increased potential for suction entrapment.
If not a single, unblockable outlet, in the event of one suction outlet being completely blocked, the remaining
suction outlets serving the system shall have a flow rating capable of the full flow of the pump(s) or the specific
suction system. If in doubt about the rating and/or head loss curve of your system, consult a qualified pool or
spa professional and/or your respective equipment manufacturer(s). Also, double check with your local building/
health authorities regarding single vs. multiple drain installations, etc.
5