Speck pumps BADUJET Inspiration Manual De Servicio, Instalacion Y Funcionamiento página 9

Installation (In-Ground Pools) - continued
Wooden decks: The BaduJet Inspiration has to be bolted all the way through the wood. (Hardware not
n
provided for this installation).
For pools that have approximately 7" between the top of the deck and the water level.
1. Remove the top cover from the BaduJet Inspiration. There are two (2) #10-24 phillips head screws securing the cover to
the base.
2. Remove the clear protective film from the front cover.
3. Place the BaduJet Inspiration on the deck where it is going to be mounted. (NOTE: The center line of the nozzles should
be 10" to 13" below the water level for maximum e ciency.) Use the holes in the BaduJet Inspiration base as a template to
locate the anchor holes. Once the holes are marked for drilling remove the unit.
NOTE: Brick and coping may need to be removed and replaced
with concrete. Attempt to keep the unit level.
4. Using the masonry bit that is provided, drill the mounting holes.
(NOTE: Drill hole in concrete 1-1/4" deep.)
5. Press the M8 pool deck anchor (part# 25) into the pre-drilled
hole.
6. Install the four (4) rubber mounts (part# 26) into the four (4)
M8 pool deck anchors (part# 25). Tighten down completely. (See
Figure 3)
NOTE: The standard for pool decking is ¼" slope per foot away
from the pool. If the slope from the front anchors to the back
anchors is 1", compensate by installing the rubber mounts in the
back and fastening the front of the unit directly to the deck (no
rubber mounts) using two (2) M8 x 40mm hex-head bolts (not
included).
7. Place the unit on the rubber mounts or on deck if rubber
mounts cannot be used. Install the 8.4 x 24mm washer (part#
30), 8.4mm lock washer (part# 31), and bolts. If using the rubber
mounts, install M8 x 25mm hex-head bolts (part# 32) . If you are
not using the rubber mounts, install the M8 x 40mm bolts. (See
Figure 4)
For pools that have approximately 3" - 5" between the top of the
deck and the water level requires a customizing kit with spacers
to raise the BaduJet Inspiration. Please call for optional lift kit.
8. Turn the pool wall adjusting screw (part# 23/1) to level the
BaduJet Inspiration.
9. Continue to Initial Start-Up Section on page 12.
. 3 "
1 1
1 4
. 5 "
Figure 3
32
31
30
26
25
Figure 4
Drill Holes
26
1-1/4" Deep
25
. 8 "
1 3
32
31
30
26
25
9