Service And Maintenance; Pump Service And Maintenance; Mechanical Seal Replacement - Speck pumps BADUJET Inspiration Manual De Servicio, Instalacion Y Funcionamiento

Operation - continued
Lights ON-OFF (press)
Unit ON-OFF (press)
Air regulation OPEN-CLOSED (turn)
Figure 10
5

Service and Maintenance

Pump Service and Maintenance

The pump requires little or no service other than reasonable care. The mechanical seal may become worn and/or loose during
the course of time, depending on the running time and water quality. If water continually leaks out, a new mechanical seal
should be installed.
After long periods of NO operation (seasonal storage, etc.), the pump must be checked for ease of rotation while it is switched
o . Using a small screwdriver, remove small circular cover at the rear of the motor exposing the motor shaft. Turn the shaft
clockwise or counter-clockwise using a wrench to check for ease of rotation. Pump should be primed after long periods of
non-operation.

Mechanical Seal Replacement

WARNING: The pump must be serviced by a professional service technician qualified in pool/spa installation. The following
procedures must be followed exactly. Improper installation and/or operation can create dangerous electrical hazards, which
can cause high voltage to run through the electrical system. This can cause property damage, serious personal injury, and/
or death. Improper installation will void the warranty.
WARNING: Before servicing the pump, YOU MUST UNPLUG THE GFCI CORD FROM THE ELECTRICAL OUTLET. Severe
personal injury or death may occur if the pump starts while your hand is inside the pump.
1. Turn OFF the pump. UNPLUG the GFCI cord from the electrical outlet.
2. Remove the top cover from the BaduJet Inspiration. There are two (2) #10-24 Phillips-head screws securing the cover to
the base (one on each side).
3. Drain water from the pump by loosening the union nuts and opening the air purge valve.
4. Remove the wire cover from the back of the motor. Disconnect the three (3) wires. Loosen the strain relief and remove
the cable from the motor.
14
Figure 11 - Badu Swim Mirror