Identification Of Symbols On The Chainsaw - STERWINS PCS 38 Manual De Instrucciones

IDENTIFICATION OF SYMBOLS ON THE CHAINSAW

Symbols have been engraved on the chainsaw for a safe operation and maintenance.
According to these indications, please be careful to not commit any error.
Fuel mix fill cap.
Position: Fuel cap.
Bar oil fill cap.
Position: Oil cap.
Adjusting the switch to the "O" position, the engine will stop immediately.
Position: Left back side of the unit.
Starting the engine. Pulling the air lever (at the right back side of the rear handle)
towards where the arrow points, can adjust the starting way as follows:
• CHOKE position – start up when the engine is cold.
• RUN position – normal start up.
Position: Right top side of the cover of the air´s filter.
The screw under the mark "H" is the screw to adjust the high speed.
The screw under the mark "L" is the screw to adjust the low speed.
The screw at the left side of the mark "T" is the screw to adjust the idle speed.
Position: Left side of the rear handle.
Shows the chain´s brake position (white arrow) which is the normal work position
and (black arrow) to activate the chain´s brake.
Position: In front of the chain´s cover.
24