ARIETE 1385 Manual De Instrucciones página 12

GB
HOW TO MAKE A CAPPUCCINO
To make cappuccino, hot chocolate or heat any beverage,
move switch (C) to the steam position ( ) and wait until C F
D
the warning light (D) goes off, which indicates that the
heating unit has reached the right temperature to produce
steam (approximately 150º C).
WARNING: if small spurts of steam come out of the
ring holder while waiting for the steam, this is com-
pletely normal. At this point turn the steam switch (F)
down, making sure to position the cup under the MAXI
CAPPUCCINO device (H): at first a little water will come
out immediately followed by a strong jet of steam.
Lift lever (F) to stop the steam and place the pitcher of milk
H
to froth under the MAXI CAPPUCCINO device. Immerse
the wand into the pitcher of milk down to the bottom and
lower the lever (F) again to obtain the desired froth.
During these operations you will notice that the warning light (D) goes on and off at regular intervals
indicating that the boiler's temperature is keeping the water required for the steam supply at the right
temperature. It is best to start steam flow only when the warning light is off.
REUTILIZATION FOR COFFEE
Move the switch (C) to the central position to cool off the heating unit. To cool the heating unit more
quickly, proceed as follows: after placing the receptacle under the wand (H), move the switch (C) to
position ( ) (for coffee brewing) and immediately lower the level (F) (for making steam): this will
cause water to flow out, until the warning light (D) turns back on. At this point, release the lever (F)
and move the right switch (C) to the central position. The coffee maker is now ready to brew coffee
again.
PERIODICAL CLEANING
WARNING: all cleaning operations must be carried out with the coffee maker turned off.
Cleaning the filter containing the ground coffee. Make sure the tiny holes are not blocked and if
necessary clean them with a brush. Make sure that the hole below them is not blocked, if necessary
clean with a pin.
Cleaning the ring filter housing. With use a sediment of coffee grounds may form in the housing
where the filter ring is placed. They can be removed with a toothpick. Periodically clean the perfo-
rated disc by running water without putting the filter ring in its housing.
Cleaning the MAXI CAPPUCCINO attachment.
Carry out this operation when the chromed tube is cool to avoid getting burned. Unscrew the
device (H) from the wand and rinse under running water. The wand can be cleaned using a non-
abrasive cloth.
Rescrew the cappuccino attachment until it reaches the end. If necessary clean the hole where the
steam comes from with a pin.
10