Error Messages; Quick Setup Error Messages - Panasonic BL-WV10 Guía De Configuración Inicial

Getting Started
2

Error Messages

2.1

Quick Setup Error Messages

Error Message
Camera setup error
Confirm connections and
try again (EA1)
This camera's firmware is
out of date
Update camera firmware
(EA2)
Camera firmware is out of
date
Update camera firmware
(EA3)
Network setup error
Check default settings
and router settings (EA4)
22
Causes and Solutions
This error is displayed if at some point during Quick
Setup, connection with the camera was lost, which
prevents Quick Setup from completion.
• Check all cables, press the FACTORY
DEFAULT RESET button on the camera, and
re-perform Quick Setup.
This error is displayed when the firmware for a
camera connected using Quick Setup is out of date.
The camera will be registered as a remote camera,
but that severely limits its functionality.
• After upgrading the firmware, erase the
camera from the camera list and re-register it.
This error is displayed when the firmware for a
camera connected using Quick Setup is out of date.
The camera will be registered as a remote camera,
but that severely limits its functionality.
• After upgrading the firmware, erase the
camera from the camera list and re-register it.
Quick Setup cannot be performed if the subnet mask
for the router is set to either 255.255.255.248 or
255.255.255.252.
• Use a subnet mask setting of 255.255.255.0.
If the router's subnet mask is not 255.255.255.0, you
will need to set the BL-WV10's [Starting Address]
setting manually.
• From the [Camera] tab on the [General Setup]
screen, set the [Starting Address] to a value
that corresponds with the network segment
address of the router.