Wireless - Panasonic BL-WV10 Guía De Configuración Inicial

Getting Started
Issue
It's taking a lot of time to
register the cameras.
The image from network
cameras is not visible.
A signal from a wireless
router is being received,
even though you're not
using one.
When 2 BL-WV10 units
are connected, the IP
addresses are the same.
3.7

Wireless

Issue
The image from cameras
for which Quick Setup was
performed is not visible.
36
Causes and Solutions
Network layouts may require a camera re-start, in
which case registration can take up to 3 minutes.
During Quick Setup, the BL-WV10, after obtaining
network data from the router, will seek out an IP
address not currently in use for its own fixed IP. In
addition, there are fixed IP addresses for cameras on
which Quick Setup was performed. If the same IP
address is chosen after Quick Setup, this will cause
network problems.
• Either change the IP settings for one of the
duplicate IP devices, change the network
settings for the BL-WV10 and the camera(s),
or re-perform Easy Network Setup after
resetting the default settings for the BL-WV10
and re-initializing the camera(s).
This will happen when wireless information is
received from connected devices which support
Panasonic's Quick Setup protocol (including the
BL-WV10 itself).
When using Quick Setup for more than one
BL-WV10, the same IP address will be used for each.
• Change the IP addresses to avoid duplication
on the network.
Causes and Solutions
When you stand in front of a camera with a PRIVACY
button (less than 1 m in front of the camera), does the
PRIVACY button turn green?
If not:
• Change the camera's switch from wired to
wireless.
If it is already set to wireless, re-register the
camera using Quick Setup.
If so:
• Check the wireless signal strength. Refer to
the wireless communication information on
page 4 and move the camera to a better
position.