Standard Operation Mode Error Messages - Panasonic BL-WV10 Guía De Configuración Inicial

Getting Started
2.2

Standard Operation Mode Error Messages

Error Message
Incorrect security code.
(ED1)
Cannot connect to
camera. (ED2)
Cannot communicate with
the camera. (ED3)
Settings could not be
saved. (ED4)
Enter a name for the
Preset. (ED5)
The timer could not be set
because the recording
start and end time are the
same. Set a different start
or end time. (ED6)
24
Causes and Solutions
This error is displayed if the security code entered to
display the [General Setup] or [Camera Setup]
screens is incorrect.
• Enter the correct security code. If you've
forgotten it, press the FACTORY DEFAULT
RESET button to reset the BL-WV10 and
re-register all cameras using Quick Setup.
This error is displayed when the camera cannot be
accessed.
• Check the camera's power and connections
and its IP address as displayed in the camera
settings.
• If using wireless cameras, refer to the wireless
communications information on page 4.
This error is displayed when the camera cannot be
accessed.
• Check the camera's power and connections
and its IP address as displayed in the camera
settings.
• If using wireless cameras, refer to the wireless
communications information on page 4.
This error is displayed if a camera's access is lost
when changing local camera settings.
• Check the camera's power and connections
and its IP address as displayed in the camera
settings.
This error can also be displayed if unusable
characters were used to register a camera name for
preset registration or local camera settings.
• Register using appropriate characters.
This error is displayed if, during preset registration,
the registered name field is left blank.
• Enter a preset registered name.
This error is displayed if the start and end times for
timer recording are the same.
• There must be a difference of at least one
minute between start and end times.