peerless-AV PLA 50-UNL Manual De Instalación página 7

Installation to Concrete Wall
• Concrete must be 2000 psi density minimum. Lighter density concrete may not hold concrete anchor.
• Make sure that the supporting surface will safely support the combined load of the equipment and all attached hard-
ware and components.
• Never exceed the Maximum Load Capacity of 150 lb (68 kg).
1 Make sure that wall plate (A) is level, use it as a tem-
plate to mark six mounting holes. The top mounting slots
should be located 3.9" below the desired screen center.
Use the masonry bit to drill six 5/16" (8 mm) dia. holes to
a minimum depth of 1.75" (45 mm). Attach wall plate (A)
using concrete anchors (W) and washers (P) as shown in
1-1 through 1-4.
1-1
Align hole in wall plate (A) with hole in wall. Gently
hammer in concrete anchor as shown.
1-2
Use a 10 mm wrench (not provided) to tighten concrete
anchors (W) to 80 in • lb (9 N.M.) maximum torque as
shown.
WARNING
• Tighten concrete anchor bolt firmly, but do not over-
tighten. Overtightening can damage the bolt, greatly
reducing its holding power.
• Never tighten in excess of 80 in • lb (9 N.M.).
WARNING
• Always attach concrete expansion anchors directly to
load-bearing concrete.
• Never attach concrete expansion anchors to concrete
covered with plaster, drywall, or other finishing mate-
rial.
1-4
INCORRECT
mounting
plate
plaster/
dry wall
CORRECT
mounting
concrete
plate
plaster/
dry wall
WARNING
1-1
Drill hole(s) and insert anchor(s) (W)
1-2
Place plate over anchor(s) (W) and secure with screw(s)(O)
1-3
Tighten all fasteners
W
concrete
7 of 39
mounting
plate
P
O
ISSUED: 06-05-06 SHEET #: 202-9140-5 12-12-06
concrete
surface
W
W
A