Machine Storage; Troubleshooting - Bissell SPOTLIFTER 2X 1719 Serie Guia Del Usuario

Maintenance & Care

machine storage

1. Clean exterior surface of spotlifter 2X with a
soft cloth dampened with water only. Do not use
a strong detergent or other cleaners as this may
damage the finish.
2. store spotlifter 2X in a protected dry area,
at room temperature (40° to 110°F).
battery removal and disposal
notE: the battery must be removed from the
Spot lifter 2X before it is disposed of.
1. important: Unplug charger.
2. Remove tanks (front and rear) and discard.
3. Remove screws (6) holding product
housings together.
4. Use a screwdriver to score rating label on
bottom of unit.
5. separate housings and locate battery pack
in bottom/center of unit.
notE: If the battery is leaking, do not touch
it. contact your local authorities for a safe
disposal or recycling facility in your area.
6. Remove wire connectors from the battery pack.
7. Keep battery pack together – DO NOT
separate individual batteries. For specific
disposal instructions of batteries, please contact:
RbRC (Rechargeable battery Recycling
Corporation) 1-800-723-1297 or visit
www.rbrc.com.
8. Discard remainder of product.
www.bissell.com
8
Tip
» Check spray nozzle for
accumulated dirt or
debris. If necessary, clean
with soft bristle brush.
WaRnInG
This product contains a rechargeable nickel cadmium
battery (sometimes referred to as a "Ni-Cad" battery)
pack. The average life of a Ni-Cad battery is 5 to 7 years,
depending on frequency of use. Proper removal and
disposal of Ni-Cad batteries is required.
3.
screws

Troubleshooting

problem possible causes
Collection/dirty tank is full
Collection/dirty tank drain plug is
Reduced
loose
suction or
batteries weak/undercharged
no suction
Collection/dirty tank not properly
installed
solution/clean tank is empty
Pump not primed
Reduced
spray or
no spray
batteries weak/undercharged
spray tip clogged
Charger plug/cord not connected
Spotlifter 2X
is not
powered or
underpow-
ered
Collection tank drain plug is loose
Charger plug/cord not connected
Spotlifter
2X will not
charge
batteries have charging resistance
Other maintenance or service not included in the manual should
please do
be performed by an authorized service representative.
not return
Thank you for selecting a bissell product.
this product
for any questions or concerns, bISSEll is happy to
to the store.
be of service. contact us directly at 1-800-237-7691.
Remedies
empty collection/dirty tank
Check plug for snug fit
Recharge according to instructions
snap tank into place
Refill solution/clean tank
While spotlifter 2X is turned on,
press spray trigger and gently rock
spotlifter 2X back and forth
Recharge according to instructions
Rinse tip with clean water
Make sure charger plug is completely
plugged into wall outlet and charging
cord is completely plugged into port
on back of unit. Make sure spot lifter
2X is stored with power switch in "O"
(OFF) position
Check plug for snug fit
Make sure charger plug is completely
plugged into wall outlet and charging
cord is completely plugged into port
on back of unit. Make sure spot lifter
2X is stored with power switch in "O"
(OFF) position
To recharge, first completely exhaust
the battery, recharge it, then exhaust
it once again before recharging a
second time. This procedure may be
required more than once
www.bissell.com
9