Opening The Unit - Acuity Brands LITHONIA LIGHTING AFFINITY AFF Instrucciones De Instalación

Page 2
Provide each unit with a single-phase power supply from a 120 V through 347 V, 50/60Hz circuit used for normal lighting. The PEL option
provides an additional switched input connection. If Switched Hot input is connected to a live wire, the lamps will always be illuminated,
otherwise the Lamps will illuminate as a function of the photosensor.
PRODUCT DAMAGE WILL OCCUR IF THE RATED INPUT VOLTAGE IS EXCEEDED.
NOTE: The battery must be connected to the charger board prior to applying AC power to the unit. Battery damage may occur if the
battery is connected longer than 24 hours without continuous AC power provided. See also "Important Battery Information", page 6.
To meet the minimum illumination requirements of NFPA 101 (current Life Safety Code), the maximum mounting height
NOTE:
from ground of WT is 14.6 feet and of FCT is 14.6 feet
This unit should be mounted ONLY through a pair of the preformed keyholes onto a 4" "OCTAGON" junction box, or
NOTE:
through a pair of the keyhole knockouts onto a 4" "SQUARE" junction box, or using conduit entry.

OPENING THE UNIT

Use a flat head screw driver,
locate the slots, one on each side
and two on top, and twist screw
driver in each slot.
JUNCTION BOX MOUNTING
-Images shown below may vary from actual product-
Feed the supply leads through
1
the junction box and prepare the
lead ends to make connections
to the fixture leads.
Ground wire
4
Mount the rear housing on the junction box with suitable hardware (not supplied).
AFFINITY
INSTALLATION and WIRING
On the rear housing, remove the
2
round center knockout (1.2"
diameter) and the desired pair of
keyhole knockouts.
®
LIFE SAFETY SOLUTIONS
TEL: 800-705-SERV (7378)
techsupport-emergency@acuitybrands.com
Top housing
slots
Rear housing
Junction boxes accommodated:
4" Square
4" Octagon
3-1/2" Round or Octagon
Single Gang Box
www.lithonia.com
Front housing
Route the supply leads through
3
the knockout and attach them to
the respective leads
fixture. Attach the
ground wire to the unit ground
wire.
on the
incoming