Final Assembly - Acuity Brands LITHONIA LIGHTING AFFINITY AFF Instrucciones De Instalación

SURFACE CONDUIT MOUNTING
NOTE: to avoid interference with components in the housing, use the most compact wire connectors appropriate to the wire gauge.
PREPARING THE UNIT FOR CONDUIT :
1
Remove the conduit plug from inside. The
unit is threaded to accept 1/2" NPT threads
(14 TPI), which are common in rigid
conduit and EMT connector products.
Rigid conduit or EMT fittings can be
directly threaded into the housing without
the need for a locknut. For wet locations,
use an approved wet location fitting.
Sized for ½" conduit
* A right angle screwdriver may be required to break
the plug from the paint

FINAL ASSEMBLY

Ensure all wires
1
connectors are routed to
avoid interference with other
components. Line up the
alignment pins (located at
diagonally opposite corners
of the front housing) with the
mating receptacles (two on
the rear housing).
SWITCH AIMING (FCT optics)
Note: Ships standard as WT option (wide throw mode)
1
Press and hold TEST button (Refer Page 4, Fig 1) for about 9 seconds to switch light beam aiming.
AFFINITY
INSTALLATION and WIRING (CONTINUED)
Conduit plug
and To properly close the unit, it
2
is important to push the
cover straight onto the rear
housing. If the pins are not
aligned with the receptacles,
the housing will not close
properly. Make sure there
are no gaps between the
front and rear housings. If
gap is present, open the unit
and
housing.
®
LIFE SAFETY SOLUTIONS
TEL: 800-705-SERV (7378)
techsupport-emergency@acuitybrands.com
BRANCH CIRCUIT WIRING :
2
The wiring compartment is sized for (3) incoming 12 AWG
wires and (3) outgoing 12 AWG wires and common wire
connectors. If your branch circuit is a larger AWG or you have a
need for a through-wire application, install the branch circuit
raceway such that you do not have to pass the circuit through
the fixture.
Open
(Clockwise) *
Alignment pin
reinstall the front
www.lithonia.com
Sheet metal
clip
Page 3