Assembly Procedure - Logan PRO SAW F100-2 Manual De Instrucciones

Instruction Manual

Assembly Procedure

A. Angle Pivot
1. It may be necessary to re-tighten angle block screw
and angle pivot screws with wrench supplied, due to
shipping.
2. Pull up angle pivot handle and test rotation. Tighten
angle block until it drags (Fig. 1).
3. Tighten pivot screws and test rotation. It should be
firm without any "play" either up and down or side to
side (Fig. 2).
B. Fence
1. Tighten both rear thumb screws (Fig. 4 & 5).
2. Tighten front anchor screw so that it matches the
indentation on the edge of the fence (Fig. 6).
3. Repeat steps 1 and 2 for left hand fence.
4. To attach extension fence, feed the fence section
into connectors extending from one another
(Fig. 7).
5. Tighten connectors with thumb screws (Fig. 8).
Fig. 4
Fig. 7
3
Logan Graphic Products Inc., 1100 Brown Street, Wauconda, IL 60084 Toll Free 1 800 331 6232 www.logangraphic.com
PRO SAW
Fig. 5
Model F100-2
Angle Block
Fig. 2
Fig. 8
Fig. 1
Screws
Fig. 6