How To Assemble Your Ceiling Fan Blades And Cap - Fanimation DRONE FPD6235 Serie Manual Del Usuario

How to Assemble the Ceiling Fan Blades and Cap
1.
Position blade over the motor assembly flywheel.
Make sure the blade is fully seated against the flywheel.
Place blade plate over the blade with holes aligned and
assemble blade to flywheel using serrated head screws,
but don't fully tighten. (Figure 1)
2.
Assemble the lower blade plate to the blade by aligning
holes of the lower blade plate with the blade holes on the
bottom of the fan and using the washer head screws.
(Figure 2)
3.
Fully tighten the screws that attach the blades to the
motor assembly flywheel. (Figure 3)
4.
Attach the plastic cap assembly to the blade.
Cap is held in place by a magnet. (Figure 4)
HARDWARE USED:
#10-32
SERRATED HEAD
SCREWS
BLADE PLATE
Lower Blade Plate
HARDWARE USED:
#8-32
WASHER HEAD
SCREWS
8
#10-32
Serrated Head Screws
(3 each per blade)
Blade Plate
Motor Assembly
Blade
Figure 1
x 9
x 3
#8-32
Washer Head Screws
(2 each per blade)
Figure 2
x 6
#10-32
Serrated Head Screws
Blade
Figure 3
Plastic Cap Assembly
Figure 4