c. ANTI-TIP BRACKET INSTALLATION INSTRUCTIONS
To reduce the risk of tipping of the range, the range must be secured to the floor by properly installed anti-tip bracket and
screws packed with the range. Failure to install the anti-tip bracket will allow the range to tip over if excessive weight is place
on an open door or if a child climbs upon it. Serious injury might result from spilled hot liquids or from the range itself.
If range is ever moved to a different location, the anti-tip bracket must be also moved and installed with range.
Instructions are provided for installation in wood or cement fastened to the floor. When fastening to the floor, be sure that
screws do not penetrate plumbing.
Anti-tip bracket installation:
1.
The anti-tip bracket must be installed to hold the right rear leg of range.
2.
If the range is place into a range opening, place the anti-tip bracket so that the closed edge of the bracket is against the
rear wall and its right side against cabinet adjacent.
3.
If the range is not place into a range opening, just place the anti-tip bracket so that the closed edge of the bracket is
against the rear wall.
4.
To mount anti-tip bracket to wood floor, use the bracket to mark where to drill mounting holes. Use a drill with a 1/8"
drill bit to drill the two holes. Use the two screws provided to fasten anti-tip bracket to floor.
5.
To mount anti-tip bracket to concrete or ceramic floor, use the bracket to mark where to drill mounting holes. Use a
drill with a 3/16" drill bit to drill the two holes. Tap plastic anchors into mounting holes in floor with hammer. Line up holes
in anti-tip bracket with holes in floor.
Use the two screws provided to fasten anti-tip bracket to floor.
6.
Move range close to opening. Plug the power supply cord into the grounded outlet and gas supply line.
7.
Move range into position making sure right rear leveling leg slides into anti-tip bracket.
ELECTRICAL CONNECTIONS
Floor
mount
Rear leveling
leg
Anti-tip
bracket
Slide Range
back