Danby DER2009W Manual Del Usuario página 39

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

For conduit installations only:
Disconnect power before servicing.
Use 8-gauge copper wire or 6-gauge
aluminum wire.
Purchase a squeeze connector matching the diameter of your conduit and assemble it in the hole. Insert the conduit through
the squeeze connector and tighten. Allow enough slack to easily attach the wires to the terminal block.
Important: Do not install the conduit without a squeeze connector. The squeeze connector should be installed before
reinstalling the range wiring cover.
3-WIRE CONDUIT INSTALLATION
Use this method only if local codes permit connecting ground conductor to neutral supply wire.
Remove the wire cover (on the back of range) by removing 3 screws using a Phillips screwdriver. The terminal block will
then be accessible.
Remove the knockout located on bracket directly below the terminal block as needed for conduit connection. To remove
the knockout, use a pair of pliers to bend the knockout ring away from the bracket and twist until ring is removed.
Assemble a U.L.-listed conduit connector in the opening.
Strip the insulation back 1 inch from the end of each wire.
Use only ring terminals to connect the power supply.
Allow enough slack in the wire to easily attach the wiring terminal block.
Use a ¼" nut driver and remove the hex washer head nuts from the terminal block.
Connect the line wires (1 and 2) to the outside terminals and the neutral wire to the center terminal. Securely tighten nuts
for proper electrical connection. Do not remove the ground strap.
Tighten the locking ring of the conduit connector.
Re-install the wire cover with the 3 screws removed earlier. Make sure the wires do not become pinched between the wire
cover and main back.
4- WIRE CONDUIT INSTALLATION
Use this method for new installations and whenever 4-conductor installation is required.
Remove the wire cover (on the back of range) by removing 3 screws using a Phillips screwdriver. The terminal block will
then be accessible.
Remove the knockout located on bracket directly below the terminal block as needed for conduit connection. To remove
the knockout, use a pair of pliers to bend the knockout ring away from the bracket and twist until ring is removed.
Assemble a U.L.-listed conduit connector in the opening.
Strip the insulation back 1 inch from the end of each wire.
Use only ring terminals to connect the power supply.
Allow enough slack in the wire to easily attach the wiring terminal block.
Remove the ground-link screw from the range frame. Save the ground-link screw. Bend the ground link away from the
range so that it does not contact the range.
Connect the green ground wire from power supply cord to the range using the ground-link screw. The ground wire must
be attached first and must not contact any other terminal.
Use a ¼" nut driver and remove the hex washer head nuts from the terminal block.
Connect the line wires (1 and 2) to the outside terminals and the neutral wire to the center terminal. Securely tighten nuts
for proper electrical connection.
Tighten the locking ring of the conduit connector.
Re-install the wire cover with the 3 screws removed earlier. Make sure the wires do not become pinched between the wire
cover and main back.
WARNING:
Electrical Shock Hazard
Electrically grand range.
Failure to follow these instructions can
result in death, fire or electrical shock.

Publicidad

Tabla de contenido
loading

Tabla de contenido