Electrical Requirements - Danby DER2009W Manual Del Usuario

This range must be properly installed and grounded by a qualified technician in accordance with the National Electrical Code
ANSI/NFPA No. 70 - latest edition
This range must be connected by means of "Permanent Wiring" or "Power Supply Cord Kit" to the proper electrical voltage and
frequency as specified on the model/serial rating plate.
If using a power supply cord, the plug must be plugged into an appropriate outlet that is properly installed and grounded in
accordance with all local codes and ordinances.
If using a direct wire connection, this range must be connected to a grounded metal, permanent wiring system; or an
equipment-ground conductor must be run with the circuit conductors and connected to the equipment-ground terminal or
lead on the range.
When installing Permanent Wiring, do not leave excess wire in range compartment. Excess wire in the range compartment
may alloy the Rear Access Cover to be replaced properly and could create a potential electrical hazard if wires become
pinched. Connect only as instructed under "Permanent Wire Connections". When using flexible conduit or range cable use flex
connector or range cable strain relief. NOTE: USE COPPER OR ALUMINUM CONDUCTORS
To remove the Rear wire cover is necessary to follow these instructions:
1. Remove the main top from the range
2. Remove the screw A located as is showed on Figure 1
3. Remove the screws B and C located on Rear wire cover as is showed on Figure 2
4. Take the cover off from the range
To replace the Rear wire cover proceed in reverse. Make sure the cover is fully engaged.
a. MODELS WITH FACTORY CONNECTED POWER SUPPLY CORD
Some models may be equipped with a factory connected four (4)-conductor power supply cord. It is to be used when the
appliance will be installed where grounding through the neutral conductor is prohibited.
1
Copies of standards listed may be obtained from:
National Fire Protection Association
Batterymarch Park
Quincy, Massachusetts, 02269

ELECTRICAL REQUIREMENTS

1
- and Local Electrical Code requirements.
screw A
Figure 1
Remove the
screws B and C
Figure 2