Inserting Or Replacing The Batteries; Ketosens Blood Β-Ketone Test Strip - i-SENS KetoSens Manual Del Usuario

Inserting or Replacing the Batteries

The KetoSens Meter uses two 3.0 V lithium batteries.
Before using the meter, check the battery compartment and
insert batteries if empty.
When the symbol appears on the display while the meter is in
use, the batteries should be replaced as soon as possible. The test
results may not be saved if the batteries run out completely.
Step 1
Make sure the meter is turned off. Push the
cover in the direction of the arrow to open
the battery compartment.
Step 2
Remove the old batteries one by one by
lifting with the index finger and pulling it
out with your thumb and index finger as
shown in the figure on the right. Insert two
new batteries with the + side facing up and
make sure the batteries are inserted firmly.
Step 3
Place the cover on the battery
compartment. Push down until you hear the
tab click into place.
Note: Removing the meter batteries will not affect your
stored results. However, you may need to reset your meter
settings. See page 14.
10 www.i-sens.com
KetoSens Blood β-Ketone Test Strip
The KetoSens blood β-Ketone monitoring system measures
blood β-Ketone quickly and accurately. It automatically absorbs
the small blood sample applied to the narrow edge of the strip.
Contact bars
Gently push the test strip, with its
contact bars facing up, into the test
strip port of meter
Insert
Confirmation window
Check here to see whether sufficient
blood sample has been applied
Edge to apply blood sample
Apply blood sample here for testing
www.i-sens.com 11