ETI 54677441 Guía De Uso Y Cuidado página 7

Installation (continued)
NOTE: Please refer to below wire and curcuit diagram if end user has demand for the 0-10V dimmer installation.
Connect the black wire and wire L together.
□
Connect the white wire and wire N together.
□
Connect the green wire and earth wire together.
□
Connect the purple wire and the anode of the dimmer, and connect the gray wire and the cathode of the dimmer.
□
Finally, fix all of them with single wire connector (CC).
□
Purple(+)
Anode(+)
Gray(-)
Cathode(-)
5
Attaching the housing to the ceiling
Drill a 1/8 in. pilot hole into the screw locations marked on the ceiling. You can also use an awl or nail to dimple the screw holes.
Install a drywall anchor (EE) and a mounting screw (FF) in each drilled mounting hole, but do not tighten fully.
Align the 4 mounting keyholes on the housing (A) with the 4 mounting screws in the ceiling. Once the screw heads are through the
large ends of the keyholes, slide the housing until the heads of the screws slide into the narrow ends of the keyholes.
Finish tightening the mounting screws (FF) until the fixture housing (A) is tightly secured to the mounting surface.
NOTE: The drywall anchors (FF) are only to be used for mounting the fixture onto plaster or drywall surfaces.
Black(+)
White(-)
Green(E)
AA
EE
DIM+
L
LED Power (DRIVER)
N
A
FF
7
Please contact 1-855-384-7754 or further assistance.
DIM+
0-10V
-
DIM-
LED+
LED-
Dimmer
LED lamp panel
www.ETiSSL.com