V2 GOLD400D Manual Del Usuario página 49

DISPLAY DATA DESCRIPTION
St.rt Operation modes
StAn - Start inputs from terminal board are disabled
no - Standard operation
AP.CH - Separated opening and closing commands
PrES - Manned operation
oroL - Timer operation
FrEn 0 ÷ 10 Brake function
StoP STOP input
no - STOP input not available
- STOP command stops the gate: START command starts moving in the opposite
invE
- STOP command stops the gate: pressing the START command gate continues the
ProS
Fot 1 PHOTO 1 input
APCh - Input is available for the connection of the photocell
no - Not available
Fot 2 PHOTO 2 input
CFCh - Photocell is active in closing and also when the gate is still
no - Not available
Ch - Photocell is active during the closing
tESt Test of safety devices
no - Function not active
Foto - Test enabled only for photocells
CoSt - Test enabled only for safety edges
Ft.Co - Test enabled either for photocells or for safety edges
CoS1 no/Si Border 1 input (fixed border)
CoS2 no/Si Border 2 input (mobile border)
C.WE no/Si Enabling WIRELESS edges
FC.En no/Si End of stroke inputs
ASM 0.5" ÷ t.AP Anti-skid function
no - Function disabled
SEnS 0 ÷ 10 Obstacle sensor level
Cont Counter viewing
tot. - Total number of completed cycles (views in thousands or in units)
Man - Number of cycles before the next request for service (such a number has been
APPr Automatic learning of the operation time
no - Function disabled
Go - Start up of the automatic learning procedure
FinE End of programming
no - It does not exit from the program menu
Si - It exits from the program menu by storing the setup parameters
Pd8 FUNCTION TABLE
direction
motion
rounded off to hundreds and it can be set up on 1000-step; in case it is set up
on 0, the request will be disabled and no will be viewed)
47
MEMO
DEFAULT
DATA
StAn
0
no
no
CFCh
no
no
no
no
Si
1.0"
0
tot
no
no