Routine Inspection; Operation; After Finishing The Work; Maintenance - Skymsen MAXICONV VP Manual De Instrucciones

correct one.
4.2.3 Precautions
The electric cable has to be compatible with the power required by the machine. Cables
touching the floor or close to the machine need to be protected against short circuits.

4.3 Routine Inspection

4.3.1 Advice
When checking the tension of the belts or chains, DO NOT introduce your fingers between
the belts and the pulleys and nor between the chain and the gears.
4.3.2 Precautions
Check if motors and sliding or turning parts of the machine produce abnormal noises.
Check the tension of the belts and chains and replace the set when belt or chain show
signs of being worn out.
When checking tensions of belts or chain DO NOT introduce your fingers between belts
and pulleys, nor between the chains and gears.
Check protections and safety devices to make sure they are working properly.

4.4 Operation

4.4.1 Advice
Be sure your hair is not loose in order to avoid getting caught by turning parts which could
lead to a serious accident. Tie your hair well up and/or cover your head with a scarf.
The operation performed by not trained or skilled personnel shall be forbidden.
Never touch turning parts with your hands or in any other way.
NEVER operate machine without all original safety devices under perfect conditions.

4.5 After Finishing The Work

4.5.1 Precautions
Always TURN THE MACHINE OFF by removing the plug from the socket before cleaning the
machine.
Never clean the machine unless it has come to a COMPLETE STOP.
Put all components back to their functional positions before turning it ON again. DO NOT
place your fingers in between belts and pulleys nor chains and gears.

4.6 Maintenance

4.6.1 Danger
Any maintenance with the machine in working situation is dangerous. TURN IT OFF BY
PULLING THE PLUG OFF THE SOCKET DURING MAINTENANCE.
20