Assembly - Attaching The Fan Blades - Home Decorators Collection 91122 Guía De Uso Y Cuidado

Assembly - Hanging the Fan (continued)
6
Mounting the fan-motor assembly
(close-to-ceiling mount)
WARNING: The locking slots of ceiling canopy are provided only
as an aid to mounting. Do not leave the fan assembly unattended
until all four canopy screws are engaged and firmly tightened.
□
Carefully unhook the fan from the mounting bracket (A) and
align the locking slots of the ceiling canopy (C) with the two
screws in the mounting bracket (A). Push up to engage the
slots and turn clockwise to lock in place. Immediately tighten
the two mounting screws firmly.
□
Install the two mounting screws (HH) and lock washers
(WW) (saved from Assembly Step 1 "Prepairing for mount-
ing" into the holes in the canopy (C) and tighten firmly.
□
Install the decorative canopy ring (M) by aligning the ring's
slots with the screws in the canopy (C). Rotate the ring
clockwise to lock in place.
□
You may now proceed to attaching the fan blades.

Assembly - Attaching the Fan Blades

1
Attaching the blade brackets
IMPORTANT: Insert the rubber plug (EE) to prevent water from
entering the switch housing and to reduce the risk of fire,
electric shock, or other personal injury.
□
Remove and save the rubber plug (EE) from the switch cup (UU)
to allow screw driver access when attaching blade arms.
□
Fasten the blade bracket (I) to the motor (F) by inserting the
alignment post into the slot on the bottom of the fan-motor
assembly (F) and tightening the motor screws that are pre-
assembled to the blade bracket (I).
□
Repeat for the remaining four blade brackets (I).
□
Insert the rubber plug (EE) into the hole in the switch cup (UU).
WW
HH
UU
EE
11
Please contact 1-800-986-3460 for further assistance.
A
D
C
F
HOMEDEPOT.COM/HOMEDECORATORS
I