Dexter 150MD2.5 Instrucciones Legales Y De Seguridad página 166

FR
2. SAFETY INSTRUCTIONS
ES
EXTRA SAFETY REGULATIONS CONCERNING MINI GRINDERS:
PT
SAFETY WARNINGS COMMON FOR GRINDING, SANDING,
IT
POLISHING OR ABRASIVE CUT
a) This power tool is intended to function as a grinder, sander, polisher
EL
or cut-
and specifications provided with this power tool. Failure to follow
PL
all instructions listed below may result in electric shock, fire and/or serious
injury.
UA
b) Operations such as wire brushing or carving are not recommended
to be performed with this power tool. Operations for which the power
RO
tool was not designed may create a hazard and cause personal injury.
c) Do not use accessories which are not specifically designed and
recommended by the tool manufacturer. Just because the accessory
EN
can be attached to your power tool, it does not assure safe operation.
d) The rated speed of the grinding accessories must be at least equal to
the maximum speed marked on the power tool. Grinding accessories
running faster than their rated speed can break and fly apart.
e) The outside diameter and the thickness of your accessory must
be within the capacity rating of your power tool. Incorrectly sized
accessories cannot be adequately controlled.
f) The arbour size of wheels, sanding drums or any other accessory
must properly fit the spindle or collet of the power tool. Accessories
that do not match the mounting hardware of the power tool will run out of
balance, vibrate excessively and may cause loss of control.
g) Mandrel mounted wheels, sanding drums, cutters or other
accessories must be fully inserted into the collet or chuck. If the
mandrel is
the mounted wheel may become loose and be ejected at high velocity.
h) Do not use a damaged accessory. Before each use inspect the
accessory such as abrasive wheels for chips and cracks, sanding
drum for cracks, tear or excess wear, wire brush for loose or cracked
wires. If power tool or accessory is dropped, inspect for damage or
install an undamaged accessory. After inspecting and installing an
accessory, position yourself and bystanders away from the plane of
the rotating accessory and run the power tool at maximum no-load
speed for one minute. Damaged accessories will normally break apart
during this test time.
tool. Read all safety warnings, instructions, illustrations
ntly held and/or the overhang of the wheel is too long,
F OPERATIONS:
166