Dexter 150MD2.5 Instrucciones Legales Y De Seguridad página 170

FR
ES
e) When wheel is pinched, snagged or when interrupting a cut for any
reason, switch
PT
until the wheel comes to a complete stop. Never attempt to remove
the cut-
IT
otherwise kickback may occur. Investigate and take corrective action to
eliminate the cause of wheel pinching or snagging.
EL
f) Do not restart the cutting operation in the workpiece. Let the wheel
reach full speed and carefully re-enter the cut. The wheel may bind,
PL
walk up or kickback if the power tool is restarted in the workpiece.
g) Support panels or any oversized workpiece to minimize the risk of
wheel pinching and kickback. Large workpieces tend to sag under their
UA
own weight. Supports must be placed under the workpiece near the line of
RO
cut and near the edge of the workpiece on both sides of the wheel.
h) Use extra caution when making a "pocket cut" into existing walls
or other blind areas. The protruding wheel may cut gas or water pipes,
EN
electrical wiring or objects that can cause kickback
2. SAFETY INSTRUCTIONS
the power tool and hold the power tool motionless
wheel from the cut while the wheel is in motion
170