Project Source 21-K822-PSD Manual De Instrucciones página 5

ASSEMBLY INSTRUCTIONS
4. Insert spray assembly (B) down through the spray
support (C) and sink (4.1). Attach spray assembly hose
(B) to the connection (4.2) beneath the faucet (A) by
tightening the swivel nut (4.3) by hand, then use pliers
(not included) for 1/4 extra turn. Be careful not to twist
the hose or overtighten the nut.
5. IF NOT INSTALLING SIDE SPRAY
From under sink, thread hose connection cap (D)
onto hose connection beneath the faucet (A). Tighten
hose connection cap (D).
DO NOT OVERTIGHTEN.
6. Make connections to water lines (6.2). Use 1/2 in. IPS
faucet connections (6.1) (not included) or use coupling
nuts (6.4) (not included) with 3/8 in. OD ball-nose
riser (6.3) (not included). HAND TIGHTEN. DO NOT
OVERTIGHTEN. Caution: Do not use PTFE pipe tape,
plumber's putty, pipe dope or any other type of sealing
compound on water inlet or threads. Additional com-
pound is not necessary. A water tight seal between
the thread inlet and supply tube is acheived by
compression.
4
4.1
4.2
5
6
6.2
5
A
4.3
B
A
D
6.2
6.1
6.4
Lowes.com
C
6.3