Preparing The Filter For Use; Using The Filter - Philips HR2170 Manual De Instrucciones

EnglisH
10
- Do not process dry ingredients for more than 1 minute.
- Cut solid ingredients into smaller pieces before you put them in the blender jar. Do not process
a large quantity of solid ingredients at the same time. Process these ingredients in a series of
small batches instead.
- If you are not satisfied with the results when you blend solid ingredients, use the pulse setting a
few times to let the blender run briefly. If you want to use a spatula, switch off the appliance,
open the lid and then stir the ingredients. You can also remove some of the contents of the jar
and process smaller amounts.
- To crush ice cubes, put max. 5 cubes in the jar at a time and press the ICE button a few times.
HR2170 only: The jar is made of glass and therefore breakable. Do not drop the jar on a hard
floor. Also avoid extreme thermal shocks. If the jar is very cold, rinse it well with lukewarm water
before you pour hot liquid into it. If the glass jar cracks, stop using it.
Filter (HR2168/HR2167 only)
You can use the filter to obtain extra finely blended sauces, fresh fruit juices or cocktails. All pips and
skins are caught in the filter.
HR2170/HR2160: You can order the filter (type number HR2963) from your Philips dealer.
Never fill the filter beyond its metal part.
Do not use the filter to process hot ingredients.

preparing the filter for use

1 Assemble the blender jar onto the motor unit (see section 'Preparing the blender for use' in
this chapter).
2 Put the filter in the blender jar (Fig. 8).
Make sure the filter is placed properly on the bottom of the jar.
The grooves of the filter and the ribs inside the blender jar help you put the filter in the right
position.
3 Close the lid.

using the filter

1 Put the ingredients in the filter through the opening in the lid.
Cut fruits into smaller pieces and soak dried pulses, such as soy beans, before you process them in
the filter.
2 Add water or another liquid.
3 Put the measuring cup in the lid, set the control knob to the highest speed and let the
appliance run for max. 40 seconds.
4 Set the control knob to 0 and remove the blender jar from the motor unit.
5 Pour out the drink through the spout of the blender jar (Fig. 9).
Make sure the lid is closed and the measuring cup is in the lid. This prevents pulp and skins from
ending up in your drink.
6 For optimal results, put the jar with the remaining ingredients back onto the appliance,
without opening/removing the lid. Then let the appliance run for a few more seconds.
7 Pour out the rest of the drink.
8 When you have finished processing, set the control knob to 0 and unplug the appliance.