Quick-Cleaning The Blender Jar - Philips HR2170 Manual De Instrucciones

EnglisH
12
Note: See the chopper table at the end of this user manual for the recommended quantities and
processing times.
Do not exceed the maximum quantities indicated in the table.
Tip: Precut large pieces of food into pieces of 1-2cm.
5 Put the lid on the chopper bowl (1) and turn it clockwise to fix it (2) (Fig. 17).
Note: Make sure the lid is properly fixed before you switch on the appliance.
6 Switch on the appliance.
Note: If the appliance shakes because the food is not evenly distributed, put your hand on the lid.
Note: The chopper does its work in a few seconds. Never let it run longer than a few seconds.
7 When you have finished processing, set the control knob to 0 and unplug the appliance.
8 Turn the chopper bowl anticlockwise (1) and remove it from the motor unit (2). (Fig. 18)
9 Turn the coupling unit clockwise (1) and remove it from the bottom of the chopper
bowl (2) (Fig. 19).
10 Remove the lid and the blade unit from the chopper bowl.
Be careful when you handle the blade unit. The cutting edges of the blade unit are sharp.
11 Empty the chopper bowl.
Always remove blade unit from the chopper bowl and the chopper from the motor unit before
you empty the chopper bowl.
cleaning (Fig. 20)
Never use scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone
to clean the appliance.
1 Switch off and unplug the appliance.
2 Disassemble all removable parts before you clean them.
3 Clean the different parts of the appliance as indicated in the cleaning table.
Tips:
- Cleaning the appliance and its parts is easiest immediately after use.
- If necessary, clean the mesh of the filter with a very soft brush.

Quick-cleaning the blender jar

1 Fill the blender halfway with warm water and add a few drops of washing-up liquid.
2 Turn the control knob to the pulse setting a few times.
3 Detach the blender jar, empty it and rinse it under the tap.
storage
1 To store the mains cord, push it into the cord storage compartment in the base (Fig. 21).
2 Store the appliance in a safe and dry place.