Publicidad
Idiomas disponibles
Idiomas disponibles
5
5 HOLE DRILLING
Remove template. Drill holes on Door Markings (5A) as shown on template. Refer to template for hole size dimensions.
6
6C
6B
6 HANDLING DEVICE SETTING
This Device (6A) is factory set for a LHR door use. For a RHR door use, rotate the device 180° as shown. Change Setting Screw (6C) to upper position and change Holding Screw (6D)
to upper hole position.
7
7B
CHASSIS
7A
7 EXIT DEVICE INSTALLATION
Remove Cover (7A) from Exit Device (7B). Place Exit Device (7B) onto Door (7C) keeping it horizontally level and aligning mounting holes with holes drilled. If you have an exterior trim that
has an actuating shaft or a tailpiece, you must allow shaft or tailpiece to align inside the Cam (7D) of Exit Device (7B). Mount Exit Device (7B) with appropriate Screws (7E), either by engaging
with exterior trim or securing directly onto Door (7C).
5A
5A
SIDE JAMB
VERTICAL
CENTER LINE
5A
6A
6D
LHR DOOR HANDLING
FACTORY SET
VERTICAL
CENTER LINE
HORIZONTAL
CENTER LINE
7C
JAMB
DOOR
HORIZONTAL
CENTER LINE
FLOOR
6A
RHR DOOR HANDLING
SET AT INSTALLATION
INSTALLATION
7B
7E
7E
4 / 20
5A
6D
PUSH BAR
7B
7D
6C
6B
Publicidad
