Publicidad
Idiomas disponibles
Idiomas disponibles
13
DOOR
13A
13C
13B
FOR AN 8' [ 2438 mm]
13 TOP ROD INSTALLATION
The Top Rods (13A & 13B) are provided to ?t a 7' [2134 mm] & 8' [2438 mm] door. For an 8' door connect Top Rods (13A & 13B) with the two sided threads Fastener Bit (13C) as shown. For a
7' door use Top Rod (13B) that contains one threaded end hole. Screw threaded end of Top Rod (13B) half way onto Top Latch Pin (13D). Connect Rod Connector (13E) onto Actuating Plate
(13F) and secure with the provided Screw (13G). Measure Top Rod (13B) to the edge of Rod Connector (13E) and mark a Cutting Line (13H) on Top Rod (13B) as shown. Remove Top Rod
(13B) and cut the excess portion. Deburr edges. Remove Rod Connector (13E) and insert it into the non-threaded end of Top Rod (13B). Tighten Setting Screw (13J) on Rod Connector (13E)
until is securely fasten to Top Rod (13B). Re-install Top Rod (13B) to Top Latch Pin (13D) and to Actuating Plate (13F) and secure with the provided Screw (13G).
14
PUSH BAR
DEPRESSED
DOOR OPENS
LATCHES
RETRACT
PUSH BAR
DOOR
FLOOR
14 ADJUST & TEST
When Push Bar (14A) is depressed and the door opens, the Top Latch (14B) and Bottom Latche (14C) should retract. Press and release the Push Bar (14A) to test latch operation. When Push
Bar (14A) is depressed both Top Latch (14B) and Bottom Latche (14C) are to retract allowing door to open. When Push Bar (14A) is released both Latches (14B & 14C) remain retracted until
door closes. Both Latches (14B & 14C) engage when the door closes. Open and close door to check for clearance and locking operation. If Device does not work smoothly, adjust Latches
Rods (14D) accordingly.
13D
THREADED END
13F
13B
DOOR
DOOR
PUSH BAR
RELEASED
DOOR
LATCHES
RETRACTED
TOP STRIKE
14B
14D
14A
14D
14C
BOTTOM STRIKE
NON-THREADED END
13B
13E
13H
DEVICE BODY
13G
ADJUST AND TEST
DOOR
REMAIN
PUSH BAR
14B
DOOR
14D
14D
14C
7 / 20
13B
13E
13J
13F
DOOR
DOOR
CLOSES
LATCHES
ENGAGE
TOP STRIKE
DOOR
14A
FLOOR
FLOOR
13D
13B
DEVICE BODY
13G
13E
DOOR
PUSH BAR
TOP STRIKE
14B
14D
14A
14D
14C
BOTTOM STRIKE
Publicidad
