Kohler Vanity K-2451 Guia De Instalacion página 10

Remove/Adjust the Door(s) and Hinges (cont.)
Depth - to move the door in or out - Loosen the screw on the
bottom and top hinge assembly, hold the door in the desired
position, then retighten the screws.
Hinges
Removal:
For a bottom hinge -
Remove the cover plate from the hinge base by sliding the cover
plate out toward you, then away from the hinge base.
For a top hinge -
Refer to the "Remove/Adjust the Hinge Assembly" section, then
proceed with the following instructions.
For both hinges -
Remove the two screws from the hinge cup, then the two screws
from the hinge base.
Relocate for left-pivot:
For vanities with a single door only - Install the hinges to the
pre-drilled holes on the left side of the door opening on the
vanity. Turn the door 180°, then reinstall the door to the hinges
on the vanity.
Replacement/Reinstallation:
Align the hinge base with the pre-drilled screw holes on the side
of the vanity. Secure with two screws.
Align the hinge cup with the pre-drilled screw holes on the door.
Secure with two screws.
Line up the latch pin on the hinge cup with the groove on the
hinge base, then snap into place.
Reinstall the cover plate and hinge assembly.
1049900-2-B 10 Kohler Co.