Install Hood Mounting Bracket; Install Upper Flue Mounting Bracket; Install The Hood - Best WTD9M Serie Instrucciones De Instalación

6. INSTALL HOOD MOUNTING BRACKET

!
When cutting or drilling into wall, do not damage electrical
wiring and other hidden utilities.
Ensure that the wall is solid enough to withstand the weight
of the hood.
If necessary, construct a wall framing using minimum 2" x 4" lumber. Proper
structural support is required to accomodate the weight of the hood.
After the wall surface is finished, measure and mark the center of the
installation; draw the vertical center line up to the ceiling.
Carefully center and level the hood mounting bracket over the installation
location. Secure it to the wall framing using 3 no. 10-12 x 2½" screws.

7. INSTALL UPPER FLUE MOUNTING BRACKET

NOTE: The upper flue mounting bracket is packed with the decorative
flue, but the mounting bracket screws are in the parts bag of
the hood.
Center the upper flue mounting bracket with the center line drawn in the
previous step and place it flush with the ceiling.
Use the upper flue mounting bracket as a template to mark the position of
the screws.
Secure the upper flue bracket to the wall using 3 no. 10-12 x 2½" screws.
Ensure that the bracket is tight against the wall.

8. INSTALL THE HOOD

BE CAREFUL when installing the decorative flue and hood, they may have sharp edges.
DO NOT REMOVE the protective plastic film covering the decorative flue (upper & lower) yet.
1. Align the hood and center it above the hood mounting bracket. Gently lower the hood until it securely engages the bracket.
2. Level the hood.
3. While the hood is hanging in place, secure it to the wall through both holes located in the upper back of hood
using 2 no. 10-12 x 2½" screws and washers. If required, pre-drill holes before securing the screws.
4. Using at least 1 hole on each side of the lower back of the hood, secure the hood into solid material (wall studs)
using 2 no. 10-12 x 2½" screws and washers. If required, pre-drill holes before securing the screws.
HD1087
WARNING
HD1083A
C
EILING
S
CREW LOCATIONS
HD0377
WARNING
!
CAUTION
HD1084A
5
C L
M
OUNTING BRACKET
FLUSH WITH CEILING
R
ANGE HOOD BACK VIEW
U
PPER HOLES LOCATION
L
OWER HOLES LOCATION