OPERATION
• The finest lawns are obtained by mowing
often. The lawn becomes more even and the
grass clippings more equally distributed over
the mown area. The total time taken is not
increased as a higher operating speed can be
used without poor mowing results.
• Do not mow wet lawns. The mowing result is
poorer because the wheels sink into the soft
lawn, clumps build, and grass clippings fasten
under the cowling.
• When mowing large areas, start by turning to
the right so that clippings will discharge away
from shrubs, fences, driveways, etc. After one
or two rounds, mow in the opposite direction
making left hand turns until finished.
• Clean the mower deck underside with water
after each use. Make sure the mower is cooled
and the engine is off.
• Use compressed air to clean top surface of the
deck. Do not flood water on the top surface,
engine and electrical components.
16
Moving Machine By Hand
When pushing or pulling the mower when the
engine is not running, engage the bypass valves.
CAUTION! With the bypass valves open,
the mower will have unrestricted motion if the
parking brake is not engaged. Do not open
the bypass valves when the mower is not on a
level surface.
1. Park on a level surface and engage the park
brake.
2. Move the steering / park brake controls
inwards to the neutral position.
3. Turn the two bypass valves counter clockwise
(as you are facing the mower) one full turn to
the open position.
4. Release the park brake and push the mower
to the desired location
Load the machine into truck or trailer by driving
slowly up the ramps. DO NOT LIFT! The machine
is not intended to be lifted by hand.