Environmental Protection - Worx WG183E Manual Original

OPERATION INSTRUCTIONS
WARNING! The charger and battery pack are
specially designed to work together so do not
attempt to use any other devices. Never insert or allow
metallic objects into your charger or battery pack
connections because of an electrical failure and
hazard will occur.
1. AUTOMATIC LINE FEED SYSTEM
When initially switching on the trimmer, a small length of
line is fed out.
A 'clattering' noise will be heard for a short time. This is
normal and is caused by the line being cut by the line
cutter. Once the line is cut to the correct length, the
'clattering' noise will stop and the trimmer motor will run
at full speed.
To feed more line, stop the trimmer completely, then
restart, allowing the motor to reach full speed. Repeat
this until you hear the 'clattering' noise of the line
cutting. (Do not repeat this procedure more than 6
times)
2 . MANUALLY FEEDING THE LINE (See Fig. H)
Press and release manual line feed button, whilst gently
pull out the lines until the lines reaches the line cutter.
When the required amount of line is fed out, gently pull
on the second line (there is no need to press the manual
line feed button again). If the line extends past the line
cutter, too much line has been fed out. If too much line is
fed out, remove the spool cap and rotate the spool anti-
clockwise until the line is at the desired length.
Removing the Cap (See Fig. I)
Press and hold in the two latches. Pull the spool cap
14
away from the Cutting Head. Keep the cap and spool
holder clean from debris. To replace the cap, press
it firmly towards the spool holder. Ensure that it is
correctly connected by trying to remove it without
depressing the two latches.
Changing the Line Spool (See Fig. K, L)
First take off the cap and remove the old spool. Place
new spool into cutting head. Feed one line through the
eyelet, then repeat for second line (See Fig. L).
Release line from cleat on the Spool. Reattach the cap.
WARNING! Your Trimmer is designed to only use
line with a maximum diameter of 0.065"(1.65mm).
Only use nylon line.
IMPORTANT - Always wind the line onto the upper
section of the spool first.
3. Manually winding the line (See Fig. M, N, O, P)
Take approximately 5 m line and insert 15 mm of line into
one of the holes in the upper section of the spool. Wind
the line in the direction of the arrows on the top of the
spool.
Leave approximately 100mm of line unwound and place
it into the cleat. Repeat on the lower section of spool.
Care should be taken to ensure that the line is neatly
coiled on the spool. Failure to do so will impair the
efficiency of the automatic line feed. Then fit the spool
as described above in "Changing the Line Spool".
Cordless Grass Trimmer
STORING YOUR GRASS
TRIMMER
Always remove the battery pack from your
trimmer after use.
To store your GRASS trimmer
The trimmer is provided with a hanging slot for storing
the trimmer on the wall. (See Fig. Q)
Store in a dry place where the trimmer and battery can
be protected from damage.
MAINTENANCE
Always remove the battery pack from your
trimmer after use.
Always check the product prior to being used for
any damage.
After use, disconnect the battery from the tool and
check for damage.
Your power tool requires no additional lubrication or
maintenance. There are no user serviceable parts in
your power tool. Never use water or chemical cleaners
to clean your power tool. Wipe clean with a dry cloth.
Always store your power tool in a dry room temperature
location. Keep the motor ventilation slots clean. Keep all
working controls free of dust.
ENVIRONMENTAL
PROTECTION
Waste electrical products must not be disposed
of with household waste. Please recycle where
facilities exist. Check with your local authorities or
retailer for recycling advice.
EN