Sunea screen io
The awning makes a brief movement
a
The end limits are set and no io control point
has
been
programmed.
«Programming the first Somfy io local control point».
or
The awning does not move
b
Press the Up or Down button, and follow procedure
«b1» or «b2» according to the awning's reaction.
The awning still does not move
b1
The end limits are not set and no io control point
has been programmed.
Go to the section «Pre-programming the Somfy io
local control point».
or
b2
The awning is fully raised or lowered
The end limits are set and the io control point has
been programmed.
Go to the section «Operation».
5.2.
Pre-programming the Somfy io local control point
-
Press the Up and Down buttons simultaneously: the awning will make a brief movement; the Somfy
io local control point has been pre-programmed into the
motor.
5.3.
Checking the motor's direction of rotation
1) Press the Up button on the Somfy io local control point:
a) If the awning is raised, the direction of rotation is
correct: go to the section «Setting the end limits».
b) if the awning is lowered, the direction of rotation is
incorrect: press the «my» button until the awning moves;
the direction of rotation has been modified.
2) Press the Up button to check the direction of rotation.
5.4.
Setting the end limits
The end limit setting depends on the type of awning.
5.4.1.
Setting for vertical awnings without upper stop, and lateral arm-mounted
awnings
For vertical awnings without upper stop, or lateral arm-mounted awnings without head
rail, the upper and lower end limits must be set.
4
Go
to
the
section
Copyright © 2010 Somfy SAS. All rights reserved.
Programming the
1st Somfy io local
control point
Pre-programming the
Somfy io local
control point
1
a
b
2
b1
or
b2
Operation
Setting
the end limits