Culligan US-DC1 Instrucciones De Instalacion Y Uso página 5

3 3
Hand-tighten the water supply adapter to the
cold water shut-off valve as shown.
Hand-tighten the lower end of cold water line
onto the top of the water supply adapter.
5
Using the mounting bracket, mark with a
pencil the holes for the mounting screws on
the wall surface.
Using a 1/8˝ drill bit, drill two pilot holes
for the mounting screws. Insert mounting
screws into the wall with a screwdriver,
leaving approximately 3/8˝ of each mounting
screw exposed.
Hang the system head on the eyes of
the bracket.
4
Choose an easy-to-access area under the
sink to mount the filter system.
NOTE: Allow 2˝ of clearance below
system to allow space for filter changes.
The filter system must be mounted in a
vertical position.
NOTE: Filter head should be mounted on
a stud or firm surface.
6
INLET
Determine two different lengths of 3/8˝
tubing needed to connect the system head
inlet and outlet to the water supply adapter
(reference image above for inlet and outlet
location). Make sure to allow enough tubing
to prevent kinking in the line.
Cut each 3/8˝ plastic tubing squarely on
both ends with a utility knife, making sure
not to crimp the tubing during cutting.
5
2˝
OUTLET