Culligan US-DC1 Instrucciones De Instalacion Y Uso página 6

7
Wet one end of the 3/8˝ plastic tubing
with water and push it into the inlet side
of the system head approximately 5/8˝
until it stops. Connect the other end of the
tubing to the inlet side of the kitchen
faucet adapter.
Repeat same process with the outlet side.
NOTE: Reference image above for inlet and
outlet location.
9
Line up arrow on cartridge with unlocked
position on head, insert cartridge, and turn
to locked position.
INLET
OUTLET
NOTE: Routine maintenance and cartridge
replacement will not require that you
disconnect the tubing from the system
head; however, tubing may be quickly and
easily removed from the fitting if necessary.
First, turn off the water supply to the filter.
Open kitchen faucet, then press in the
collar around the fitting while pulling the
tubing with your hand.
Turn on the cold water shut-off valve.
Check for leaks.
Turn on faucet and allow water to run for
10 minutes to flush air and carbon fines
(very fine black powder).
Check for leaks before leaving
installation. If problems exist, refer to
the troubleshooting.
6
8
COLLAR
10