PULOX PO-400 Manual De Instrucciones página 13

foams and paper boxes) should follow the local laws and regulations.

Please check the packing before use to make sure the device and accessories are totally in
accordance with the packing list, or else the device may have the possibility of working abnormally.

Please choose the accessories and probe which are approved or manufactured by the manufacturer,
or else it may damage the device.

Please choose the battery chargers which should be ensured compliance with the requirements of
IEC 60601-1, or else it may damage the device.

Please don't use the device in the course of charging.

The device can only be matched with the compatible probe.

Please don't measure this device with functional tester for the device's related information.
1.3 Attention

Keep the oximeter away from dust, vibration, corrosive substances, explosive materials, high
temperature and moisture.

If the oximeter gets wet, please stop operating it.

When it is carried from cold environment to warm or humid environment, please do not use it
immediately.

DO NOT operate keys on front panel with sharp materials.

High temperature or high pressure steam disinfection of the oximeter is not permitted. Refer to
User Manual in the relative chapter (7.1) for instructions of cleaning and disinfection.

Do not have the oximeter immerged in liquid. When it needs cleaning, please wipe its surface with
medical alcohol by soft material. Do not spray any liquid on the device directly.

When cleaning the device with water, the temperature should be lower than 60°C.

As to the fingers which are too thin or too cold, it would probably affect the normal measure of the
patients' SpO2 and pulse rate, please clip the thick finger such as thumb and middle finger deeply
enough into the probe.

The pulse oximeter can be used to adult or infant. Whether the device is used to adult or infant, it
depends on the probe selected.

The update period of data is less than 30 seconds, which is changeable according to different
individual pulse rate.

The waveform is normalized. Please read the measured value when the waveform on screen is
equably and steady-going. Here this measured value is optimal value, and the waveform at the
moment is the standard one.

If some abnormal conditions appear on the screen during test process, pull out the finger and
reinsert to restore normal use.

The device has normal useful life for three years since the first electrified use.

This device has the function of alarming, users can check on this function according to chapter 6.1 as
a reference.

The device has the function of limits alarming, when the measured data is beyond the highest or
lowest limit, the device would start alarming automatically on the premise of the alarming function
is on.

The device has the function of alarming, this function can either be paused, or closed (default
setting) for good. This function could be turned on through menu operation if you need. Please
check the chapter 6.1 as a reference.

The device may not work for all patients. If you are unable to achieve stable readings, discontinue
use.
2. Overview
The pulse oxygen saturation is the percentage of HbO2 in the total Hb in the blood, so-called the O2
concentration in the blood. It is an important bio-parameter for the respiration. A number of diseases
relating to respiratory system may cause the decrease of SpO2 in the blood, furthermore, some other
causes such as the malfunction of human body's self-adjustment, damages during surgery, and the
injuries caused by some medical checkup would also lead to the difficulty of oxygen supply in human
body, and the corresponding symptoms would appear as a consequence, such as vertigo, impotence,
vomit etc. Serious symptoms might bring danger to human's life. Therefore, prompt information of
patients' SpO2 is of great help for the doctor to discover the potential danger, and is of great
importance in the clinical medical field.
EN