Health O Meter 500KL Instrucciones De Uso página 17

OPERATING INSTRUCTIONS (CONT)
Weighing a Patient
Note: When this scale is turned on, it will always default to the settings and units last used (LB
or KG).
1. Make sure there is nothing on the scale platform.
2. Press the ON/OFF button to turn the display assembly on. "StArt" will briefly appear on the
display, followed by "0.0" LB or "0.0" KG.
3. Ask the patient to step on the scale. The scale will begin to display weight information and will
lock on the patient's weight when the stable weight of the patient is determined. Depending on
the movement of the patient on the scale, it may take several seconds for the scale to lock onto
the weight.
Caution: To prevent patient injury, the patient must be attended throughout the entire
weighing event.
4. The weight may be held on the display by pressing the HOLD/RELEASE button. To release,
press the HOLD/RELEASE button again.
5. After the weight measurement has been taken and is recorded, have the patient step off the
scale.
6. Press the ON/OFF button to turn the scale off.
Height Measurement Instructions
WARNINGS: Use caution when sliding height rod up and down. The rod should move
smoothly; do not move the rod in a jerking motion. Fold headpiece down when not in
use.
Note: Patients must be a minimum of 23-5/8" (600mm) tall for the height to be accurately
measured.
1. With the headpiece in the folded down
position, slide the headpiece up or down to
the estimated height of the patient. Then
raise the headpiece into its horizontal
position.
17