Putting Into Operation - Abicor Binzel ABIPLAS WELD 100 Instructivo De Servicio

®
ABIPLAS WELD 100/150 POWDER W

6 Putting into operation

BAL.0086 • 2020-12-17
The plasma powder welding torches work with two independently adjustable
arcs (pilot and main arcs) that are supplied with power from the power source.
The pilot arc burns between an anodically poled copper nozzle. It is ignited by
means of a high-frequency voltage and used to ignite the main arc. The main
arc burns between the tungsten electrode and the anodically poled workpiece.
The plasma gas is expelled from the plasma nozzle's opening as a high-energy
plasma jet and provides the thermal energy required for welding. The filler
material is fed to the process in powder form. The arc and the molten pool are
protected by the inert gas or the active gas components. The cable assembly
serves as a supply line and is equipped with all connection elements.
DANGER
Risk of injury due to unexpected start-up
The following instructions must be adhered to throughout all maintenance,
servicing, assembly, disassembly and repair work:
• Switch off the power source.
• Close off the gas supply.
• Close off the coolant supply.
• Disconnect all electrical connections.
DANGER
Risk of injury and device damage when handled by
unauthorised persons
Improper repair work and modifications to the product may lead to serious
injuries and damage to the device. The product warranty will be rendered
invalid if work is carried out on the product by unauthorised persons.
• Operating, maintenance, cleaning and repair work must only be carried
out by qualified personnel (in Germany, see TRBS 1203).
NOTICE
• Please take note of the following instructions:
 3 Product description on page EN-5
This section provides all the information that must be taken into account when
putting the device into operation.
6 Putting into operation
EN - 11