Neumann Mission Guia De Instalacion página 13

a b
Check the LED status to make sure the connection is OK.
LED light display
Green light on
Green light on, while "outside working area"
shown in the screen at the same time
Green light flashing
Red light on
3.3
You can now permanently fix the charging base
on the ground by tightening the supplied Base
Fixing Nails with the supplied Hex key.
NOTE: Make sure the IN-wire is running straight
through the tunnel underneath the charging base.
3.4
Connect the power cord to the adaptor and then to
the AC electrical socket, the LED on the charging
base will turn on. When connecting, align the notch on
the power cord connector (a) with the groove on the
adaptor connector (b).
In case the power cord is within the working area, you
may bury it as needed.
Status
Boundary wire is connected successfully; fully
charged
Boundary wire is connected in wrong direction. Check and reverse two ends of
Power supply is connected successfully, while
the wire is connected unsuccessfully
Charging
Action
/
boundary wire.
Check and connect the wire again.
/
13
EN