Factory Default Settings - Motorola Solutions CLP Serie Manual Del Usuario

MN006179A01-AC
Chapter 4: Radio Programming through CPS
Figure 11: Programming the Radio through a Multi-Unit Charger
2 Set the cable switch to analog.
3 After the radio is connected, open the CPS and select Read on the toolbar to get the radio
profile.
You can change the general, audio, menu, channels, scan list, customized PL/DPL settings and
select frequencies and PL/DPL codes on each channel.
4 To save the settings, select Write to radio on the toolbar.
NOTICE: For more information on the CPS, see Help menu in the CPS.
4.2

Factory Default Settings

Your radio is programmed at the factory to the following settings.
Table 7: CLP1010e 1W UHF 1 CH Radios Default Settings-BRUS
Channel Num- Frequency #
ber
1 2
Table 8: CLP1080e 1W UHF 8 CH Radios Default Settings-BRUS
Channel Number
1
34
Frequency Set-
tings (MHz)
464.5500
Frequency Settings
(MHz)
464.55
Code Value
(Hz)
67.0
Code Value (Hz)
67.0
Bandwidth
(kHz)
12.5
Bandwidth (kHz)
12.5