From The 16-Pin Harness; From The 22-Way Harness - Axxess AX-ADGM100 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1. From the 16-pin harness:

Connect the (2) Red wires to the ignition/accessory wire of the
aftermarket radio.
Connect the Orange/White wire to the illumination wire of the aftermarket
radio. If the aftermarket radio has no illumination wire, tape off the Orange/
White wire.
Connect the Blue/White wire to the amp turn on wire of the
aftermarket radio.
Connect the Brown wire to the mute wire of the aftermarket radio. If the
aftermarket radio does not have a Mute wire, tape up the Brown wire.
Connect the White wire to the left front positive speaker output of the
aftermarket radio.
Connect the White/Black wire to the left front negative speaker output of
the aftermarket radio.
Connect the Gray wire to the right front positive speaker output of the
aftermarket radio.
Connect the Gray/Black wire to the right front negative speaker output of
the aftermarket radio.
Continues on next paragraph.
AX-ADGM100
Connections to be made

2. From the 22-way harness:

11
Only make the following if the vehicle contains a digitally amplified system:
Connect the Green wire to the radio's left rear positive speaker output.
Connect the Green/Black wire to the radio's left rear negative speaker output.
Connect the Purple wire to the radio's right rear positive speaker output.
Connect the Purple/Black wire to the radio's right rear negative
speaker output.
The following wires are for the aftermarket radios that have navigation built in:
Connect the Light Green wire to the parking brake wire of the aftermarket
navigation radio.
Connect the Blue/Pink wire to the VSS or speed sense wire of the
aftermarket navigation radio.
Connect the Green/Purple wire to the reverse wire of the aftermarket
navigation radio.
The Black/Yellow wire will be discussed later on in the instructions.
The DIN plug is to be connected to the optional AX-LCD screen if satellite
radio or RSE is being retained.
If the AX-LCD screen will be used, connect the Red wire to accessory power.
Continued next page

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido