Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Connections to be made
For non-amplified systems:
Cut the resistors from the Green, Green/Black, Purple, Purple/Black
•
right below the heat shrink.
•
Connect the Violet wire to the right rear positive wire of the
aftermarket radio.
Connect the Violet/Black wire to the right rear negative wire of the
•
aftermarket radio.
•
Connect the Green wire to the left rear positive wire of the
aftermarket radio.
•
Connect the Green/Black wire to the left rear negative wire of the
aftermarket radio.
•
The DIN plug is not used in this application.
Installing the AX-ADGM100
12-way harness
This harness is for the ASWC-1 (sold separately). Please refer to the ASWC-1
instructions for programming.
1.
With all the connections completed, plug the 22 and 16-pin harnesses into
the AX-ADGM100.
2.
Plug the 30-pin GM harness into the vehicle side harness, and plug
the aftermarket radio harness into the aftermarket radio.
Continues on next page.
AX-ADGM100
Installing the AX-ADGM100
3.
Reconnect the negative battery terminal.
4.
Initialize the interface by cycling the key by (1) turning the ignition "on" for
30 seconds, (2) then back off, and then (3) back on again to test the radio.
Video and RSE Harness
These two additional harnesses are to be used in GM LAN 29 systems only.
(1) Backup camera harness:
•
Connect the Yellow RCA to the aftermarket radios backup camera
video input.
(2) RSE harness:
•
Connect the "From rear A/V input" RCA to the aftermarket radios audio/
video input. Plug Yellow in to video in, Red to right audio in, and White to
left audio in.
•
Connect the "To overhead screen" RCA to the aftermarket radios audio/
video output. Plug Yellow in to video out, Red to right audio out, and White
to left audio out.
Connect the Black wire with the ring terminal to ground.
•
•
To activate RSE audio press and hold the source button for 1.5 seconds.
6
Publicidad
Capítulos
Tabla de contenido
