Only make the following connections if the vehicle contains a digitally
amplified system.
Connect the Green wire to the radio's left rear positive speaker output.
•
•
Connect the Green/Black wire to the radio's left rear negative
speaker output.
Connect the Purple wire to the radio's right rear positive speaker output.
•
•
Connect the Purple/Black wire to the radio's right rear negative
speaker output.
The following wires are for the aftermarket radios that have navigation built in:
Connect the Light Green wire to the parking brake wire of the aftermarket
•
navigation radio.
•
Connect the Blue/Pink wire to the VSS or speed sense wire of the
aftermarket navigation radio.
Connect the Green/Purple wire to the reverse wire of the aftermarket
•
navigation radio.
2. From the 22-way harness:
•
The Black/Yellow wire will be discussed later on in the instructions.
The DIN plug and loose Red wire will not be used in this application.
•
AX-ADGM100
Connections to be made
3. From the 30-way harness:
5
•
Connect the Black wire to the ground wire of the aftermarket radio.
•
Connect the RCA to the AUX-in on the aftermarket radio (if equipped) to
retain RSE and/or OE satellite.
•
Satellite information will be displayed on driver information center (DIC).
Connect the Yellow wire to the constant wire of the aftermarket radio.
•
•
If the vehicle is amplified disconnect the 4-pin harness located between
the 30-way and 22-way connector and connect the supplied 4-pin to
4-pin resistor pad.
For amplified systems:
Only make these connections if you do not have a "digital" amplifier.
•
Connect the Violet wire to the right rear positive wire of the
aftermarket radio.
•
Connect the Violet/Black wire to the right rear negative wire of the
aftermarket radio.
Connect the Green wire to the left rear positive wire of the
•
aftermarket radio.
•
Connect the Green/Black wire to the left rear negative wire of the
aftermarket radio.
Continued next page