How To Install Your Canopy Housing; How To Assemble Your Ceiling Fan Blades - Fanimation NAVY LP7678LBN Manual Del Usuario

How to Install Your Canopy Housing

NOTE: This step is applicable after the neccessary
wiring is completed.
1. Assemble canopy by rotating key slot in canopy
over shoulder screw in hanger bracket. Tighten
shoulder screw. Fully assemble and tighten second
shoulder screw that was previously removed.
(Figure 1)
WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy
housing and not pinched between the housing and the
ceiling.
2. Securely attach and tighten the canopy screw cover
over the shoulder screws in the hanger bracket
utilizing the key slot twist-lock feature. (Figure 2)

How to Assemble Your Ceiling Fan Blades

1. Position the blade over the blade holder with
threaded posts showing. Make sure the bottom edge
of the blade is fully seated against the blade holder.
With a phillips screwdriver, tighten 3/16˝-24 truss head
screw with spring washer/flat washer and fiber washer
to secure the blade to the blade holder. (Figure 1)
CAUTION
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.
Blade Holder
Blade
HARDWARE USED:
3/16˝-24
Truss Head Screw
With Spring Washer/
Flat Washer
Fiber Washer
11
Figure 1
Figure 2
3/16˝-24
Truss Head Screw
With Spring Washer/
Flat Washer
and Fiber Washers
(3 each per blade)
Figure 1
X 9
X 9