Mfx-Protocol - Marklin Digital 60978 Manual Del Usario

in the locomotive.
Enter a speed with the speed control knob. Now the lo-
comotive starts slowly, accelerates to the fastest speed,
and then stops after a short while. After that, the locomo-
tive tries several times to start up. If the locomotive finally
remains at a standstill, the calibration process has ended.
No other operations should be done during the entire
process.
The calibration process can be stopped with the "Stop"
button, by turning the speed control knob, by changing
the direction of travel. The process must be repeated
after such a termination.
If the results of the calibration process are not satisfactory,
calibration can be repeated with another type of motor.
The process can be repeated more than once. If the test
run does not give the desired result, you can adjust indivi-
dual parameters manually in the motor parameters. (MM/
DCC see CV tables, mfx in Locomotive Configuration in the
Central Station -> CV -> Motor). The beginning and the end
of the test run is indicated by the following light symbols.
Activated (Enter the value 77)
Start of the test run
(Speed Level > 1)
End of the test run
Termination or Interruption
Extensive information about this can be found on the Internet:
www.maerklin.de/de/produkte/tools_downloads/technische_
informationen.html
mfx Protocol
Addresses
• No address is required; each decoder is given a one-time,
unique identifier (UID).
• The decoder automatically registers itself on a Central
Station or a Mobile Station with its UID.
Programming
• The characteristics can be programmed using the graphic
screen on the Central Station or also partially with the
Mobile Station.
• All of the Configuration Variables (CV) can be read and
programmed repeatedly.
• The programming can be done either on the main track or
the programming track.
• The default settings (factory settings) can be produced
repeatedly.
• Function mapping: Functions can be assigned to
any of the function buttons with the help of the
60212 Central Station (with limitations) and with the
60213/60214/60215/60216/60226 Central Station.
Extensive information about this can be found on the Internet:
www.maerklin.de/de/produkte/tools_downloads/technische_
informationen.html
fx (MM) Protocol
Addresses
• 4 addresses (a main address and 3 consecutive addresses)
35