Philips Daily Collection HR2011/16 Manual De Instrucciones página 17

Tip: For optimal results, put the jar with the remaining ingredients back onto the appliance and let it run
for a few more seconds.
Note: When you process a large quantity, we advise you not to put all the ingredients in the filter at the
same time. Start to process a small quantity and let the appliance run for a few seconds. Then switch off
the appliance and add another small quantity. Repeat this procedure until you have processed all the
ingredients. Always keep the lid on the blender jar during processing.
8 Clean all removable parts immediately after use (see chapter 'Cleaning').
Mill (HR2011/HR2001 only)
using the mill
1 Put the ingredients in the mill beaker (Fig. 9).
You can process wet and dry ingredients.
Do not fill the mill beaker beyond the MAX indication.
2 Place the sealing ring on the mill blade unit. (Fig. 10)
Make sure that the rubber sealing ring is placed correctly.
3 Put the mill blade unit on the mill beaker (1) and screw the blade unit anticlockwise (2) until
it is fixed properly. (Fig. 11)
4 Turn the assembled mill upside down and screw it clockwise onto the motor unit
('click') (Fig. 12).
5 Put the mains plug in the wall socket.
6 Switch on the appliance and let it run until the ingredients are fine enough.
This takes approx. 10-30 seconds.
disassembling the mill
1 Unplug the appliance.
2 Screw the mill anticlockwise off the motor unit.
3 Turn the mill upside down and screw the blade unit clockwise off the mill beaker.
4 Clean all removable parts immediately after use (see chapter 'Cleaning').
Cleaning
Always unplug the appliance before you clean it.
Never immerse the motor unit in water, nor rinse it under the tap. Do not clean the motor unit
in the dishwasher.
Never use scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone
to clean the appliance.
Tip: Cleaning the appliance and its parts is easiest immediately after use.
1 Make sure the appliance is unplugged.
2 Disassemble all removable parts.
Do not forget to remove the blender sealing ring and the mill sealing ring (HR2011/HR2001
only).
Do not touch the blades. The blades are very sharp.
3 Clean the motor unit with a moist cloth.
EnglisH
17