Cleaning Your Mask At Home; Daily/After Each Use - ResMed AirFit N20 CLASSIC Guia Del Usuario

•
Adjustment tips:
−
To resolve any leaks at the upper part of the mask,
adjust the upper headgear straps. For the lower part,
adjust the lower headgear straps. Adjust only enough
for a comfortable seal.
−
Ensure the headgear straps are not overtightened or
too loose.
•
For a full list of compatible devices for this mask, see the
Mask/Device Compatibility List on
www.resmed.com/downloads/masks. If you do not have
internet access, please contact your ResMed
representative.

Cleaning your mask at home

It is important to follow the steps below to get the best
performance out of your mask.
WARNING
•
As part of good hygiene, always follow cleaning
instructions and use a mild liquid detergent. Some
cleaning products may damage the mask, its parts and
their function, or leave harmful residual vapours that
could be inhaled if not rinsed thoroughly.
• Regularly clean your mask and its components to
maintain the quality of your mask and to prevent the
growth of germs that can adversely affect your health.
CAUTION
If any visible deterioration of a system component is
apparent (cracking, crazing, tears etc), the component
should be discarded and replaced.

Daily/After each use:

Before cleaning, take the mask components apart according to
the disassembly instructions.
1. Soak and agitate the cushion and elbow in warm water
(approximately 30°C) using a mild liquid detergent for up to
10 minutes.
Clean the components with a soft bristle brush, paying
particular attention to the small vent holes on the elbow.
Rinse the components under warm flowing drinking quality
water.
Inspect each component to ensure that they are visually clean
and free of detergent residue. If required, repeat washing.
Allow the components to dry out of direct sunlight before
assembling.
Weekly:
1. Soak and agitate the separated headgear and frame in
warm water (approximately 30°C) using a mild liquid
detergent for up to 10 minutes.
Rinse the components under warm flowing drinking quality
water until they are free of detergent residue.
Squeeze the headgear to remove excess water.
Allow the components to dry out of direct sunlight before
assembling.
3