Publicidad
T-Connector Wiring Kit
INSTALLATION INSTRUCTIONS
1. Read instructions thoroughly before beginning.
2. Locate the vehicles tail light wiring harness by opening
the jack storage cover door on the left (drivers) side
rear interior trim panel. The vehicle harness will have
connectors similar to those found on the T-Connector
harness.
3. Carefully seperate the
vehicle connectors taking care
not to damage the locking tabs.
4. Insert the T-Connector
between the seperated vehicle
harness ends and firmly press
the connectors together, ensuring that the
mating ends are securely locked together.
5. The T-Connector may be retained in the jack storage
compartment when not in use.
6. Confirm correct operation with a test light or by using
a properly equipped trailer.
Optional Installation Method:
7. To route the T-Connectors 4-flat connector to the
outside of the vehicle, remove the left (drivers) side tail
light assembly by removing the two screws at the top of
the housing and pulling the assembly straight out away
Fig. 1
Publicidad
